LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1315 (Parking Brake System) >> Repair Instructions >> Enabling the Park Brake Cable Automatic Adjuster

Enabling the Park Brake Cable Automatic Adjuster

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Park Brake Cable To Rear Suspension Mounting Bracket
    GM64001Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  3. Install the park brake cable to the left and right park brake actuators.
  4. Install the rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  5. Lower the vehicle.
  6. Fig 2: Front Parking Brake Cable To Drive Sector & Park Brake Lever Assembly
    GM404107Courtesy of GENERAL MOTORS CORP.
  7. Reposition the carpet away from the parking brake lever.
  8. Remove any rivet, drill bit or cotter key from the park brake lever.
  9. Install the park brake cable to the park brake lever.
  10. Install the carpet to its original position.
  11. Cycle the park brake lever three times in order to obtain proper park brake cable tension.