Compressor Clutch Coil Removal

Tools Required

• J 8433  A/C Compressor Pulley Puller. See Special Tools and Equipment .
• J 8433-3  Forcing Screw. See Special Tools and Equipment .
• J 33023-A  Puller Pilot. See Special Tools and Equipment .
• J 33025  Clutch Coil Puller Legs. See Special Tools and Equipment .
• J 41790-A  A/C Compressor Holding Fixture. See Special Tools and Equipment .

Fig 1: View Of Compressor Mounting Fixture
Courtesy of GENERAL MOTORS CORP.
1. Remove the A/C compressor from the vehicle.
2. Clamp the J 41790-A  in a vise and attach the A/C compressor to the J 41790-A  . See Special Tools and Equipment .
Fig 2: J 33023-A & Clutch Rotor
Courtesy of GENERAL MOTORS CORP.
3. Remove the A/C compressor clutch plate and hub assembly. Refer to Compressor Clutch Plate and Hub Assembly Removal (V7 - Direct Mount) .
4. Install the J 33023-A  onto the front head of the A/C compressor. See Special Tools and Equipment .
5. Remove the A/C compressor rotor and bearing assembly. Refer to Clutch Rotor and/or Bearing Removal (V7 - Direct Mount) .
Fig 3: J 33025, J 8433, J 8433-3, J 33023-A & A/C Compressor Clutch Coil
Courtesy of GENERAL MOTORS CORP.
6. Mark the clutch coil terminal location (2) on the A/C compressor front head.
7. Install the J 33025  onto the J 8433  . See Special Tools and Equipment .
8. Install the J 8433  onto the A/C compressor clutch coil (1) and tighten the puller leg bolts. See Special Tools and Equipment .
9. Tighten the center forcing screw J 8433-3  of the J 8433  against the J 33023-A  to remove the A/C compressor clutch coil from the A/C compressor. See Special Tools and Equipment .
10. Remove the J 8433-3  , the J 33023-A  , the J 33025  and the J 8433  . See Special Tools and Equipment .