LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1311 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Blower Motor Resistor Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Blower Motor Resistor & HVAC Module
    GM295304Courtesy of GENERAL MOTORS CORP.
  1. Position the blower motor resistor forward retaining slots onto the forward retaining screws and the upper portion of the resistor into the HVAC module.
  2. Align and seat the resistor to the HVAC module.
  3. Install the resistor rear retaining screw and drive until just secure.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Tighten all the resistor retaining screws.

    Tighten:  Tighten the screws to 1.6 N.m (14 lb in).

    5. Fig 2: Blower Motor & Electrical Connector
    GM295327Courtesy of GENERAL MOTORS CORP.
  5. Connect the blower motor resistor electrical connector to the blower motor.
    6. Fig 3: Blower Motor Resistor & Wiring Harness Electrical Connector
    GM295302Courtesy of GENERAL MOTORS CORP.
  6. Connect the wiring harness electrical connector to the blower motor resistor.
  7. Install the RH lower I/P insulator panel. Refer to Closeout/Insulator Panel Replacement - Right in Instrument Panel, Gages and Console.
  8. Install the BLO MOT MaxiFuse® #49 to the I/P electrical center.
  9. Install the cover to the I/P electrical center.
  10. Install the front floor kick-up panel. Refer to Kick-Up Panel Replacement - Front Floor in Interior Trim.
scientia non olet · About LEMON Manuals