Removal Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the I/P upper trim pad. Refer to Trim Pad Replacement - Instrument Panel (I/P) Upper in Instrument Panel, Gages and Console.
- Pull the front floor carpet away from the RH side of the driveline tunnel to access the floor air outlet - inner.
- Release the floor air outlet - inner from the floor air outlet lower duct - RH rear.
Use a twisting motion to release the floor outlet from the floor duct.
- Release the floor air outlet lower duct - RH rear from the floor air outlet duct - RH rear, then remove the duct.
Use a twisting motion to release the lower duct from the duct.
- Using a flat bladed screwdriver, CAREFULLY release the floor air outlet duct - RH rear from the HVAC module.
- Lower the duct down between the I/P center support bracket and the side of the driveline tunnel, then remove the duct.