Installation Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Install the floor air outlet duct into position.
- Install the floor air outlet duct retaining screws.
Tighten: Tighten the screws to 1.6 N.m (14 lb in).
- Install the left lower closeout/insulator panel. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages and Console.
NOTE:
Refer to Fastener Notice in Cautions and Notices.