Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Retractor Side Seat Belt

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the upper retractor and attaching bolt.
Tighten: Tighten the upper retractor bolt to 41 N.m (30 lb ft).
Install the lower retractor and attaching bolt.
Tighten: Tighten the lower retractor bolt to 41 N.m (30 lb ft).

Fig 2: Lock Pillar Lower Trim Panel

Courtesy of GENERAL MOTORS CORP.

Install the lower lock pillar trim panel.
Install the sill plate.

Fig 3: Lock Pillar Upper Trim Panel

Courtesy of GENERAL MOTORS CORP.

Install the upper lock pillar trim panel.
Install the screw securing the upper trim panel.
Tighten: Tighten the upper lock pillar trim panel screw to 1.8 N.m (16 lb in).
Install the spacer and washer to the seat belt harness bracket stud.

Fig 4: Seat Belt Guide Bracket Stud & Upper Guide

Courtesy of GENERAL MOTORS CORP.

Install the upper guide to the stud.
Install the nut attaching the upper guide to the bracket stud.
Tighten: Tighten upper guide nut to 40 N.m (29 lb ft).
Snap the guide cover closed.