LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1302 (Engine Mechanical (Repair Instructions 1 Of 3) - 5.7L) >> Repair Instructions (On-Vehicle & Off-Vehicle - Part 1 >> On-Vehicle Repair Instructions >> Oil Level Indicator and Tube Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Oil Level Indicator Tube & Bolt
    GM651879Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the O-ring seal with clean engine oil.
  2. Install the oil level indicator tube into position.
  3. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  4. Insert the oil level indicator tube into the engine block until the collar is flush with the block.
  5. Lower the vehicle.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Install the oil level indicator tube bolt.

    Tighten:  Tighten the oil level indicator tube bolt to 25 N.m (18 lb ft).

    7. Fig 2: Oil Level Indicator
    GM651880Courtesy of GENERAL MOTORS CORP.
  7. Install the oil level indicator.
  8. Check the oil level and add if necessary.
scientia non olet · About LEMON Manuals