LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1302 (Engine Mechanical (Repair Instructions 1 Of 3) - 5.7L) >> Repair Instructions (On-Vehicle & Off-Vehicle - Part 1 >> On-Vehicle Repair Instructions >> Engine Mount Replacement - Right >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Engine Mount-To-Engine Mount Bracket & Nuts
    GM651864Courtesy of GENERAL MOTORS CORP.
  1. Install the engine mount heat shield to the engine mount, if necessary.
    2. IMPORTANT: When installing the engine mount be sure to have the locating dowel in the correct position.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the engine mount (left side shown, right side similar).
  3. Install the engine mount-to-engine mount bracket nut.

    Tighten:  Tighten the engine mount-to-engine mount bracket nut to 65 N.m (48 lb ft).

  4. Install the front suspension crossmember. Refer to Crossmember Replacement - Front Suspension in Front Suspension.
scientia non olet · About LEMON Manuals