LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1302 (Engine Mechanical (Repair Instructions 1 Of 3) - 5.7L) >> Repair Instructions (On-Vehicle & Off-Vehicle - Part 1 >> On-Vehicle Repair Instructions >> Drive Belt Idler Pulley Replacement - Accessory >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Accessory Drive Belt Idler Pulley Bolt
    GM651862Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure that the idler pulley and dust shield are fully seated against the shoulder on the bracket before tightening the bolt.
  1. Install the accessory drive belt idler pulley bolt until snug.
  2. Install the accessory drive belt. Refer to Drive Belt Replacement - Accessory .
    CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  3. Tighten the accessory drive belt idler pulley bolt.

    Tighten:  Tighten the accessory drive belt idler pulley bolt to 50 N.m (37 lb ft).

scientia non olet · About LEMON Manuals