Installation Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Position the latch to the retainer and finger-tighten the bolts.
- Adjust the latch using the following procedures:
- Adjust the latch up or down to make the lid flush.
- Adjust the latch side to side gap from the lid to the quarter panels.
- Tighten the latch bolts.
Tighten: Tighten the bolts to 10 N.m (89 lb in).
- Connect the electrical connector to the latch.
- Route the manual release cable down over the intermediate carpet. Position the end of the cable on the rear floor carpet.
- Refer To Compartment Lid Extension - Folding Top Stowage in Interior Trim.
- Close the lid and position the folding top to the original position.
NOTE:
Refer to Fastener Notice in Cautions and Notices.