Removal Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
The stowage lid and the rear compartment lid will contact if they are opened at the same time. Be sure that one lid is latched at all times.
- Open the rear compartment.
- Remove the rear nut attaching the folding top stowage lid hinge.
- Disconnect the right and left folding top stowage lid struts from the rear of the hinges.
- Close the rear compartment.
- Open the folding top stowage lid and support the lid.
- Place a protective cover between the stowage lid and the rear compartment lid, and over the top of the quarter panels.
- Using a grease pencil mark the location of the hinge on the lid to aid in installation.
- Remove the lid release switch harness (2) from the hinge, (drivers side hinge removal).
- Remove the nuts attaching the front of the hinge to the body.
- Remove the hinge bolts from the lid.
- Remove the hinge.