Removal Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the folding top and place the top upside down on a clean flat surface. Refer to Folding Top Replacement .
- Remove the headliner screws from the rear side rail.
- Remove the folding top front and center side rail retainers. Refer to Weatherstrip Retainer Replacement - Folding Top (Front and Center Side Rail) or Weatherstrip Retainer Replacement - Folding Top (Rear Side Rail) .
- Remove the seal compression panel from the #1 bow. Refer to Folding Top Seal Compression Panel Replacement .
- Using a pair of needle-nosed pliers, remove the top cover staples from the #1 bow.
- Peel back the top cover to expose the fabric flap on the tension cable bracket.
- Remove the headliner screws from the #1 bow.
- Remove the headliner push-on retainer from the #1 bow.
- Remove the nuts attaching the #1 bow to the front side rail.
- Remove the main control link screw from the front side rail.
- Remove the main control link screw from the center side rail.
- Remove the center rail screw from the rear side rail.
- Remove the center rail screw from the balance link.
- Remove the front and center rail assembly.