LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Steering Wheel And Steering Column) >> Adjustments >> Ignition Switch

Ignition Switch

WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 2001 Pontiac Firebird, 2001 Pontiac Bonneville, 2001 Chevrolet Monte Carlo, 2001 Chevrolet Impala, and 2001 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: New ignition switch is pinned in OFF-LOCK position. Plastic pin must be removed before operating switch.
  1. Set key lock cylinder in OFF-LOCK position. On fixed column, set ignition switch slider (where actuator rod connects to switch) to OFF-LOCK position by moving slider as far left as possible, and then one detent to right. See Fig 1.
  2. On tilt column, set ignition switch slider (where actuator rod connects to switch) to OFF-LOCK position by moving slider to right as far as possible, and then one detent to left. See Fig 1.
  3. Install switch. Tighten switch screws to 35 INCH lbs. (4 N.m). Ensure ignition switch functions properly with lock cylinder in all positions.
Fig 1: Adjusting Ignition Switch
G92G04478Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals