LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Steering Wheel And Steering Column) >> Adjustments >> BTSI & Park Lock System >> Adjustment (Floor Shift)

Adjustment (Floor Shift)

WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 2001 Pontiac Firebird, 2001 Pontiac Bonneville, 2001 Chevrolet Monte Carlo, 2001 Chevrolet Impala, and 2001 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove center console trim for access to base of shift lever. Place shift lever in Park. Turn lock cylinder to RUN position to energize BTSI solenoid. Unlock cable adjuster at base of shift lever by pressing locking button upward. Turn lock cylinder to LOCK position.
  2. On "C", "F", "H" and "Y" bodies, push cable connector nose forward to remove slack. On "E" and "K" bodies, push cable housing toward shifter to remove slack. On all models, with no load applied to cable, lock cable adjuster button by pressing locking button down. Install center console trim. Connect negative battery cable.
  3. Recheck BTSI system. If system does not operate as specified, repeat previous step.
Fig 1: Adjusting BTSI Actuator ("C" & "H" Bodies)
G95J14133Courtesy of GENERAL MOTORS CORP.
Fig 2: Adjusting Park Lock Cable ("E" & "K" Bodies)
G94C32922Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals