LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1294 (Supplemental Inflatable Restraint System) >> Diagnostic Information and Procedures >> DTC B0051 >> Conditions for Clearing the DTC

Conditions for Clearing the DTC

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

DTC B0051 is a latched code which cannot be cleared. Replace the SDM after following the instructions in the diagnostic table.

DTC B0051

Step Action Yes No
1 Did you perform the Diagnostic System Check-SIR? Go to Step 2  Go to Diagnostic System Check - SIR 
2
  1. Turn OFF the ignition.
  2. Inspect the vehicle for signs of inflator module deployment.
Does the vehicle show any signs of inflator module deployment?		 Go to Step 5  Go to Step 3 
3 Inspect the front of the vehicle and undercarriage for signs of impact/collision.
Does the vehicle show any signs of impact/collision?		 Go to Step 5  Go to Step 4 
4 Replace the SDM. Refer to Inflatable Restraint Sensing and Diagnostic Module Replacement .
Did you complete the replacement?		 Go to Step 6  -
5
  1. Install a scan tool.
  2. Turn ON the ignition, with the engine OFF.
  3. With the scan tool request the SIR DTC display.
  4. If a history DTC exists, refer to Diagnostic Aids for that specific DTC and diagnose the problem.
  5. Replace components and perform inspections as required following an accident. Refer to Repairs and Inspections Required After a Collision .
Did you complete the appropriate inspections and necessary repairs?		 Go to Step 6  -
6
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.
Does the DTC reset?		 Go to Step 2  System OK
scientia non olet · About LEMON Manuals