LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1293 (Suspension Control System - Suspension Damping) >> Repair Instructions >> Front Position Sensor Replacement - Electronic Suspension >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn OFF the ignition switch.
  2. Raise the vehicle on a suitable safety stand. Refer to Lifting and Jacking the Vehicle in General Information.
  3. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
    4. Fig 1: Front Position Sensor Connector & Mounting Bolts
    GM70242Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the position sensor connector (3).
  5. Remove the position sensor harness retainers.
  6. Remove the position sensor link from the control arm link stud (2).
  7. Remove the position sensor mounting bolts (4).
  8. Remove the position sensor (1) from the vehicle.
scientia non olet · About LEMON Manuals