LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1293 (Suspension Control System - Suspension Damping) >> Diagnostic Information and Procedures >> DTC C0695 >> Test Description

Test Description

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

The numbers below refer to the step numbers on the diagnostic table.

  1. 2:  This tests the position sensor signal voltage range using a scan tool. The scan tool will display 0 volts for all position sensors if any position sensor 8 volt reference circuit is shorted to ground.
  2. 3:  This tests if any position sensor is shorted to ground.
  3. 4:  This tests determines which position sensor is shorted to ground.
  4. 5:  Tests for a short to ground in the position sensor 8 volt reference circuits.
  5. 6:  Tests for a short to voltage in the position sensor 8 volt reference circuits.
DTC C0695

Step Action Value(s) Yes No
Schematic Reference: Suspension Controls Schematics 
Connector End View Reference: Suspension Controls Connector End Views 
1 Did you perform the Electronic Suspension Control Diagnostic System Check? - Go to Step 2  Go to Diagnostic System Check - Electronic Suspension Control 
2 
  1. Install a scan tool.
  2. Turn ON the ignition, with the engine OFF.
  3. With the scan tool, observe all four Position Sensor data parameters in the ESC data list.
Does the scan tool indicate that all four Position Sensor data parameters are within the specified range?		 0-0.2 V Go to Step 3  Go to Step 6 
3 
  1. Turn OFF the ignition.
  2. Disconnect all four position sensors.
  3. Turn ON the ignition, with the engine OFF.
  4. Use the scan tool in order to clear the DTCs.
Does the DTC reset?		 - Go to Step 5  Go to Step 4 
4  Reconnect each position sensor one at a time and observe if the DTC resets after each sensor is reconnected.
Does the DTC reset?		 - Go to Step 7  System OK
5  Test the 8 volt reference circuit of all position sensors for a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?		 - Go to Step 9  Go to Step 8 
6  Test the 8 volt reference circuit of all position sensors for a short to voltage. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?		 - Go to Step 9  Go to Diagnostic Aids
7 Replace the applicable position sensor. Refer to Front Position Sensor Replacement - Electronic Suspension  or Rear Position Sensor Replacement - Electronic Suspension .
Did you complete the replacement?		 - Go to Step 9  -
8 Replace the ESC module. Refer to Electronic Suspension Control Module Replacement .
Did you complete the replacement?		 - Go to Step 9  -
9
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.
Does the DTC reset?		 - Go to Step 2  System OK
scientia non olet · About LEMON Manuals