LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 129 (Engine Controls - Removal & Installation, Overhaul) >> Ignition Systems >> Camshaft Position Sensor >> Removal (3.1L & 3.4L)

Removal (3.1L & 3.4L)

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix, 2002 Chevrolet Monte Carlo, 2002 Chevrolet Impala, 2002 Buick Regal, and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. The Camshaft Position (CMP) sensor is located at top rear of cylinder block. See Figure. Turn ignition off. Remove the accessory drive belt from the power steering pump.
  2. Remove the power steering pump. See appropriate POWER RACK & PINION article in STEERING. Disconnect the CMP sensor electrical connector. Remove the attaching bolt. Remove the CMP sensor. Inspect the sensor "O" ring for wear, cracks, or leakage if the sensor is not being replaced.
scientia non olet · About LEMON Manuals