LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 129 (Engine Controls - Removal & Installation, Overhaul) >> Fuel Systems >> Fuel Rail & Injectors >> Removal (3.1L & 3.4L)

Removal (3.1L & 3.4L)

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix, 2002 Chevrolet Monte Carlo, 2002 Chevrolet Impala, 2002 Buick Regal, and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release fuel system pressure. See FUEL SYSTEM PRESSURE RELEASE . Remove the upper intake manifold. See appropriate article in ENGINES. Disconnect the engine fuel feed pipe at the fuel rail. See FUEL LINE DISCONNECT FITTINGS .
  2. Disconnect the engine fuel return pipe at the fuel pressure regulator. Remove the fuel feed pipe and fuel return pipe "O" rings and discard. Disconnect the main injector harness electrical connector. To disconnect fuel injector connector, pull up the lock release of the fuel injector connector. Depress the lock tab and lift the connector from the injector. Disconnect all remaining fuel injector connectors.
  3. Remove the injector electrical harness from the fuel rail. Disconnect the engine coolant temperature sensor electrical connector. Remove the fuel rail retaining bolts. See Figure. Remove the fuel rail assembly. Remove the injector "O" ring seal from the spray tip end of each injector. Discard the lower "O" ring seals.
  4. To remove injector(s) from the fuel rail, remove the fuel injector retainer clip. Remove the fuel injector from the fuel rail. Remove and discard the fuel injector upper "O" ring.
scientia non olet · About LEMON Manuals