LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1281 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Ignition Switch Lock Cylinder Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Ignition Switch Lock Cylinder Electrical Connector At Side Of Ignition Switch
    GM95718Courtesy of GENERAL MOTORS CORP.
  1. Apply the parking brake.
  2. CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  3. Disconnect the negative battery cable.
  4. Remove the console. Refer to Console Replacement .
  5. Remove the IP accessory trim plate. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory .
  6. Remove the driver knee bolster trim panel. Refer to Trim Panel Replacement - Knee Bolster .
  7. Remove the ignition switch lock cylinder electrical connector from the retaining tab on the side of the ignition switch.
  8. Fig 2: Ignition Switch Lock Cylinder Electrical Connector
    GM95717Courtesy of GENERAL MOTORS CORP.
  9. Disconnect the ignition switch lock cylinder electrical connector.
  10. Fig 3: Ignition Lock Cylinder At RH Lower Side Of Ignition Switch
    GM183232Courtesy of GENERAL MOTORS CORP.
  11. Insert the key and turn the ignition to ON.
  12. Using a flat bladed screwdriver or other suitable tool, depress and hold the ignition lock cylinder retaining tab (located on the RH lower side of the ignition switch)
  13. Fig 4: Ignition Switch Lock Cylinder Wire To Base Of Ignition Switch Bezel
    GM95684Courtesy of GENERAL MOTORS CORP.
  14. Pull to remove the ignition lock cylinder.
  15. IMPORTANT: Take note of how the ignition switch lock cylinder wire is wrapped around the base of the ignition switch bezel.
  16. Remove the ignition switch bezel.

    Carefully pull to unsnap.