LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1281 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Bracket Replacement - Knee Bolster (Passenger) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Passenger Knee Bolster Bracket To Passenger SIR Bracket
    GM95671Courtesy of GENERAL MOTORS CORP.
  1. Install the passenger knee bolster bracket as marked prior to removal.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the passenger knee bolster bracket to passenger SIR bracket retaining bolts.

    Tighten:  Tighten the passenger knee bolster bracket retaining bolts to 12 N.m (106 lb in).

    3. Fig 2: Passenger Knee Bolster Bracket To IP Center Support Bracket Retaining Bolts
    GM95682Courtesy of GENERAL MOTORS CORP.
  3. Install the passenger knee bolster bracket to IP center support bracket retaining bolts.

    Tighten:  Tighten the passenger knee bolster bracket retaining bolts to 12 N.m (106 lb in).

  4. Install the IP upper trim pad. Refer to Trim Pad Replacement - Instrument Panel (I/P) Upper .
  5. Install the IP passenger compartment. Refer to Compartment Replacement - Instrument Panel (I/P) .
  6. Install the driver knee bolster trim panel. Refer to Trim Panel Replacement - Knee Bolster .
  7. Install the IP accessory trim plate. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory .
  8. Install the console. Refer to Console Replacement .
scientia non olet · About LEMON Manuals