LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1281 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Bracket Replacement - Knee Bolster (Driver) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the console. Refer to Console Replacement .
  2. Remove the IP accessory trim plate. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory .
  3. Remove the driver knee bolster trim panel. Refer to Trim Panel Replacement - Knee Bolster .
  4. Release the ignition switch and hazard warning switch wiring harness retainers from the driver knee bolster bracket.
    Fig 1: Driver Knee Bolster Bracket To Steering Column Bracket
    GM95668Courtesy of GENERAL MOTORS CORP.
    5. IMPORTANT: The following step must be performed to assure proper trim fits during installation.
  5. Mark the location of the driver knee bolster bracket. Refer to Instrument Panel (I/P) Disassembly Precautions .
  6. Remove the screws retaining the driver knee bolster bracket to the steering column bracket.
  7. Remove the driver knee bolster bracket.
scientia non olet · About LEMON Manuals