LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1281 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Bracket Replacement - Knee Bolster (Driver) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Driver Knee Bolster Bracket To Steering Column Bracket
    GM95668Courtesy of GENERAL MOTORS CORP.
  1. Install the driver knee bolster bracket into position as marked prior to removal.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the screws which retain the driver knee bolster bracket to the steering column bracket.

    Tighten:  Tighten the driver knee bolster bracket retaining screws to 1.9 N.m (17 lb in).

  3. Secure the ignition switch and hazard warning switch wiring harness retainers to the driver knee bolster bracket.
  4. Install the driver knee bolster trim panel. Refer to Trim Panel Replacement - Knee Bolster .
  5. Install the IP accessory trim plate. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory .
  6. Install the console. Refer to Console Replacement .
scientia non olet · About LEMON Manuals