Clutch Pressure Plate Adjustment (On-Vehicle)

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Engine Flywheel Inspection Cover & Retaining Bolts

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: The aid of an assistant will be necessary during this procedure.

Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
Remove the engine flywheel inspection cover retaining bolts.
Remove the engine flywheel inspection cover.

Fig 2: Adjusting Ring Tension Spring Stops

Courtesy of GENERAL MOTORS CORP.

Have an assistant press the clutch pedal until tension is released from the clutch pressure plate stepped adjusting ring, then continue to hold the pedal.
Hold 2 screwdrivers or other suitable tools, and place them against 2 of the 3 stepped adjusting ring tension spring stops (1), just ahead of the adjusting ring tension springs.

Fig 3: Rotating The Stepped Adjusting Ring Counterclockwise

Courtesy of GENERAL MOTORS CORP.

Use the screwdrivers to rotate the stepped adjusting ring counterclockwise, compressing the tension springs, until the adjusting ring steps are fully adjusted out. Continue to hold in position.
Have your assistant release the clutch pedal.
Release the adjusting ring tension spring stops.

Fig 4: Engine Flywheel Inspection Cover & Retaining Bolts

Courtesy of GENERAL MOTORS CORP.

Install the engine flywheel inspection cover.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the engine flywheel inspection cover retaining bolts.
Tighten: Tighten the engine flywheel inspection cover retaining bolts to 25 N.m (18 lb ft).
Lower the vehicle.