Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Clutch Pedal Position Switch & Clutch Start Switch Electrical Connector

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.

Disconnect the negative battery cable.
Remove the clutch pedal position switch (clutch start switch) electrical connector.

Fig 2: Inserting A Feeler Gage Between The Switch & Clutch Pedal Bracket

Courtesy of GENERAL MOTORS CORP.

Insert a feeler gage between the switch and the clutch pedal bracket to release the switch tab.
Remove the switch.
Lift the switch slightly then pull to remove.