LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1277 (Steering Wheel And Steering Column) >> Repair Instructions >> Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement (Manual) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Steering Shaft & Components
    GM330130Courtesy of GENERAL MOTORS CORP.
  1. Install the following to the steering shaft:
    1. Inner race (1)
    2. Upper bearing inner race seat (2)
    3. Upper bearing spring (3)
    4. Turn signal cancel cam assembly (4)
    5. Shaft lock shield (5)
    2. Fig 2: Compressing Cam Orientation Plate Using J 23653-SIR & J 42137
    GM338052Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The bearing retainer must be properly seated into the groove on the steering shaft.
  2. Install a new bearing retainer onto the steering shaft assembly.
  3. Compress the cam orientation plate using J 23653-SIR and J 42137  to install the bearing retainer. See Special Tools and Equipment .
  4. Remove J 23653-SIR and J 42137  from the steering shaft assembly. See Special Tools and Equipment .
    5. Fig 3: Wave Washer & Steering Shaft
    GM293252Courtesy of GENERAL MOTORS CORP.
  5. Install the wave washer (1) onto the steering shaft assembly (2).
  6. Install the SIR coil. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement in SIR.
  7. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
scientia non olet · About LEMON Manuals