LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1277 (Steering Wheel And Steering Column) >> Diagnostic Information and Procedures >> Noise in Steering Column

Noise in Steering Column

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
Noise in Steering Column

Step Action Yes No
1 Did you review the Steering Wheel and Column Description and perform the necessary inspections? Go to Step 2  Go to Steering Wheel and Column Description and Operation 
2 Verify that noise is present in the steering column during operation.
Is noise present in the steering column during operation?
Go to Step 3  System OK
3 Inspect the steering column components for looseness.
Is the steering column components loose?
Go to Step 10  Go to Step 4 
4 Inspect the SIR/SRS coil for noise.
Is the SIR/SRS coil noisy?
Go to Step 11  Go to Step 5 
5 Inspect the horn contact ring for lubrication.
Is the horn contact ring lubricated?
Go to Step 12  Go to Step 6 
6 Inspect the lock plate retaining ring for the correct installation.
Is the lock plate retaining ring installed properly?
Go to Step 13  Go to Step 7 
7 Inspect the shaft bearing for the following conditions:
  • Damage
  • Lubrication
  • Wear
  • Proper seating

Are the bearings in need of repair or replacement?
Go to Step 14  Go to Step 8 
8 Inspect the spherical joint for lubrication.
Is the spherical joint lubricated?
Go to Step 15  Go to Step 9 
9 Inspect the steering column coupling for looseness.
Is the steering column coupling loose?
Go to Step 16  Go to Step 3 
10 Tighten the steering column components to specifications. Refer to Fastener Tightening Specifications .
Did you complete the repair?
Go to Step 17  -
11 Replace the SIR coil. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement in SIR.
Did you complete the repair?
Go to Step 17  -
12 Lubricate the horn contact ring.
Did you complete the repair?
Go to Step 17  -
13 Install the lock plate retaining ring properly.
Did you complete the repair?
Go to Step 17  -
14 Repair the shaft bearings as necessary. Refer to Steering Shaft, Lower Bearing, and Jacket Replacement (Telescoping)  or Steering Shaft, Lower Bearing, and Jacket Replacement (Manual) .
Did you complete the repair?
Go to Step 17  -
15 Lubricate the spherical joints.
Did you complete the repair?
Go to Step 17  -
16 Tighten the steering column coupling to specifications. Refer to Fastener Tightening Specifications .
Did you complete the repair?
Go to Step 17  -
17 Operate the system in order to verify the repair.
Did you correct the condition?
System OK Go to Step 3