LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1276 (Engine Controls (Introduction) -- 5.7L) >> Repair Instructions >> Evaporative Emission (EVAP) Hoses/Pipes Replacement - Engine (Vent) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: EVAP Canister & Vent Hose
    GM561128Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fuel and EVAP Pipe Caution in Cautions and Notices.
  1. Remove the caps from the EVAP vent valve and the EVAP canister.
  2. Route the vent hose over the floor panel tunnel panel rear brace.
  3. Install the clamps on the vent hose.
  4. Connect the vent hose to the EVAP canister.
    5. Fig 2: EVAP Canister Vent Valve & Vent Hose
    GM561130Courtesy of GENERAL MOTORS CORP.
  5. Connect the vent hose (2) to the EVAP vent valve.
  6. For vehicles equipped with automatic transmission, install the right muffler. Refer to Muffler Replacement - Right in Engine Exhaust.
    7. Fig 3: View Of EVAP Canister Access Cover In Right Rear Wheelhouse
    GM561137Courtesy of GENERAL MOTORS CORP.
  7. Install the EVAP canister access cover.
  8. Install the right rear wheelhouse panel. Refer to Wheelhouse Panel Replacement in Body Rear End.
  9. Lower the vehicle.
scientia non olet · About LEMON Manuals