LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1276 (Engine Controls (Introduction) -- 5.7L) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: EVAP Canister Bracket & Bolt
    GM561136Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to the Fastener Notice in Cautions and Notices.
  1. Install the new EVAP canister (1) to the EVAP canister bracket (2).
  2. Install the EVAP canister bracket bolt (3).

    Tighten:  Tighten the EVAP canister bracket bolt to 7 N.m (62 lb in).

    3. Fig 2: EVAP Canister & Purge Pipe
    GM609762Courtesy of GENERAL MOTORS CORP.
  3. Connect the purge pipe at the EVAP canister.
    4. Fig 3: EVAP Canister & Vent Hose
    GM561128Courtesy of GENERAL MOTORS CORP.
  4. Connect the vent hose to the EVAP canister.
  5. Install the right fuel tank. Refer to Fuel Tank Replacement (Right)  or Fuel Tank Replacement (Left) .
scientia non olet · About LEMON Manuals