LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1272 (Manual Transmission -- TREMEC 6-Speed) >> Repair Instructions >> Gear Select/Skip Shift Solenoid Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: J 41099 & Gear Select Solenoid
    GM71533Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Using the J 41099  , install the gear select (skip shift) solenoid. See Special Tools and Equipment .

    Tighten:  Tighten the gear select solenoid to 40 N.m (30 lb ft).

    2. Fig 2: Gear Select Solenoid Electrical Connector
    GM180654Courtesy of GENERAL MOTORS CORP.
  2. Connect the gear select solenoid electrical connector.
  3. Lower the vehicle.
scientia non olet · About LEMON Manuals