Transmission Shift Quality Quick Learn Procedure (DAKOTA - 4.7L, DURANGO - 4.7L & Ram Pickup 1500 - 4.7L)
WARNING: This page does not describe the selected car, but rather 120 other vehicles, including the 2002 Saturn Vue, 2002 Saturn SL2, 2002 Saturn SL1, 2002 Saturn SL, and 2002 Saturn SC2. However, it is still accessible from the selected car via links, so may be relevant.
This program allows the electronic transmission system to recalibrate itself. This will provide the best possible transmission operation.
- Transmission shift quality quick learn procedure must be performed to provide proper transmission operation if any of the following have been done:
- Transmission assembly was replaced.
- Transmission Control Module (TCM) was replaced.
- Solenoid pack was replaced.
- Clutch plate and/or seal replaced.
- Valve body was reconditioned or replaced.
- Transmission shift quality quick learn procedure must be performed using Chrysler's Diagnostic Readout Box (DRBIII®) scan tool. Following conditions must be met when performing transmission shift quality quick learn procedure:
- Brakes must be applied.
- Engine speed must be greater than 500 RPM.
- Throttle position sensor angle must be less than 3 degrees.
- Shift lever must remain in designated position until prompted to shift to overdrive.
- Shift lever must remain in overdrive after the shift to overdrive until scan tool indicates procedure is complete.
- Calculated oil temperature must be 60-200°F (16-93°C).
- Connect DRBIII® to Data Link Connector (DLC) below driver's side of instrument panel. Go to TRANSMISSION display on scan tool.
- Go to MISCELLANEOUS display on scan tool. Select QUICK LEARN PROCEDURE display on scan tool. Follow instructions displayed on scan tool to perform transmission shift quality quick learn procedure. After quick-learn procedure is completed, perform DRIVE LEARN PROCEDURE (DAKOTA - 4.7L, DURANGO - 4.7L & RAM PICKUP 1500 - 4.7L) .