Installation Procedure
WARNING: This page is about a different car, the 2002 GMC Safari and 2002 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
Important : Apply these items in an environment free of dust or dirt that could come in contact with the sticky backing and prevent proper adhesion.
- Clean the area where the molding or the emblem is to be mounted.
Use a suitable solvent, such as a mixture of 50 percent isopropyl alcohol and 50 percent water, or equivalent.
- Dry the area thoroughly.
- Ensure that the body area is at a temperature range of 27-41°C (80-105°F).
Heat the area, if needed.
- Ensure that the emblems are at a temperature range of 29-32°C (85-90°F.
Place the emblem, adhesive side down, on a heated surface or use a heat lamp or a heat gun in order to raise the temperature.
- Remove the protective liner on the back of the molding or the emblem.
- Apply the molding or the emblem to the body surface.
- Apply an equal amount of pressure along the molding or the emblem in order to uniformly bond the molding or the emblem to the body surface.
- Apply an equal amount of pressure along the molding or the emblem in order to uniformly bond the molding or the emblem to the body surface.