LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1236 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Roof Weld Joint Reveal >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Warm the body panel with J 25070  to a minimum of 21°C (70°F).
    IMPORTANT: Do not touch the adhesive backing on the molding.
  2. Remove the protective liner at the front edge of the weld joint molding.
  3. Align and center the front edge of the weld joint molding with the front edge of the weld joint.
  4. Use hand pressure to press the weld joint molding into place.
  5. Continue to remove the protective liner from the molding, centering the molding and pressing it into the weld joint.
  6. Hand roll the loose ends.
    Fig 1: Installing Roof Weld Joint Reveal Molding
    G01503832Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals