LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1236 (Exterior Trim) >> Repair Instructions >> Emblem/Nameplate Replacement - Rear Compartment Lid >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Apply the emblem/nameplate in an environment that is free from dust or other dirt that could come into contact with the sticky backing. Foreign material may cause improper adhesion.
  1. Clean the area where the emblem/nameplate will be installed.

    Use a lint free cloth and Varnish Makers and Painters (VMP) naphtha or a 50/50 mixture by volume of isopropyl alcohol and water to clean the area.

  2. Dry the area thoroughly.
  3. If the location of the emblem/nameplate has not been marked, apply tape and mark the location as shown below.
  4. For the GRAND PRIX emblem/nameplate install as shown.
  5. Heat the mounting surface to approximately 27-41°C (80-105°F) using the J 25070  , if necessary.
  6. Ensure that the temperature of the emblem/nameplate is approximately 29-32°C (85-90°F).
    Fig 1: Identifying Location For Installing GRAND PRIX Emblem On Rear Compartment Lid
    G01503819Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not touch the adhesive backing on the emblem/nameplate.
  7. Remove the protective liner from the back of the emblem/nameplate.
  8. Position the emblem/nameplate to the location marks and press the emblem/nameplate to the mounting surface.
  9. Apply equal pressure along the emblem/nameplate to uniformly bond the item to the mounting surface.
  10. Remove the protective tape from the mounting surface.
scientia non olet · About LEMON Manuals