LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1218 (Engine Mechanical - 3.8L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Strut Bracket Replacement - Right Upper (L67) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the right engine mount strut bracket to the cylinder head.
    Fig 1: Installing Right Engine Mount Strut Bracket
    G02083498Courtesy of GENERAL MOTORS CORP.
  2. Install the electronic ignition module harness assembly to the stud, as shown.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the right engine mount strut bracket nuts and stud.

    Tighten 

    Tighten the right engine mount strut bracket nuts and stud to 50 N.m (37 lb ft).

    Fig 2: Installing Right Engine Mount Strut Bracket Nuts And Stud
    G02083499Courtesy of GENERAL MOTORS CORP.
  4. Install the right engine mount strut to the right engine mount strut bracket. Refer to ENGINE MOUNT STRUT REPLACEMENT - LEFT  and ENGINE MOUNT STRUT REPLACEMENT - RIGHT  .
    Fig 3: Installing Right Engine Mount Strut
    G02083500Courtesy of GENERAL MOTORS CORP.
  5. Install the supercharger drive belt tensioner. Refer to DRIVE BELT TENSIONER REPLACEMENT - SUPERCHARGER  .
    Fig 4: Installing Supercharger Drive Belt Tensioner
    G02083501Courtesy of GENERAL MOTORS CORP.
  6. Install the upper supercharger drive belt idler pulley. Refer to DRIVE BELT IDLER PULLEY REPLACEMENT - UPPER  .
  7. Install the supercharger drive belt. Refer to DRIVE BELT REPLACEMENT (L36)  or DRIVE BELT REPLACEMENT (L67)  .
    Fig 5: Installing Upper Supercharger Drive Belt Idler Pulley
    G02083502Courtesy of GENERAL MOTORS CORP.
  8. Install the ignition coil. Refer to ENGINE CONTROLS - REMOVAL & INSTALLATION - V6 & V8 in Engine Performance - Removal and Installation.
  9. Connect the battery ground (negative) cable. Refer to BATTERY NEGATIVE CABLE DISCONNECT/CONNECT PROCEDURE in Battery.
    Fig 6: Installing Ignition Coil
    G02083503Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals