LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1218 (Engine Mechanical - 3.8L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Camshaft and Bearings Cleaning and Inspection >> Tools Required

Tools Required

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.

J 7872  Magnetic Base Indicator Set

  1. Measure the camshaft journals with a micrometer.

    If the camshaft journals are not within specifications, replace the camshaft. The measurement should be 47.655-46.858 mm (1.8462-1.8448 in). If the measurement is not within specifications the engine camshaft must be replaced.

    Fig 1: Measuring Camshaft Journals With Micrometer
    G02083829Courtesy of GENERAL MOTORS CORP.
  2. Measure the camshaft runout using J 7872  .
    1. 2.1. Mount the camshaft in V-blocks between centers.
    2. 2.2. Use J 7872  to check the intermediate camshaft journal.
  3. If the runout exceeds specifications, the camshaft is bent and should be replaced. If the camshaft journals are more than 0.025 mm (0.0010 in) out-of-round, then replace the engine camshaft.
    Fig 2: Measuring Camshaft Runout
    G02083830Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals