LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1217 (Engine Mechanical - 3.1L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Oil Pump Drive Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the oil pump drive seal. Coat the seal or bore in the engine block with engine oil.
  2. Coat the drive gear on the oil pump drive with prelube GM P/N 1052367 (Canadian P/N 992869) or the equivalent.
  3. Install the oil pump drive.
  4. Install the oil pump drive clamp.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  5. Install the oil pump drive bolt.

    Tighten 

    Tighten the bolt to 36 N.m (27 lb ft).

    Fig 1: Installing Oil Pump Drive Seal
    G02081450Courtesy of GENERAL MOTORS CORP.
  6. Install the fuel feed and the fuel return pipes to the fuel injector rail. Refer to FUEL RAIL & INJECTORS in Engine Performance - Removal and Installation.
  7. Install the fuel pipe clip and the bolt.

    Tighten 

    Tighten the bolt to 8 N.m (71 lb in).

  8. Install the upper intake manifold. Refer to INTAKE MANIFOLD REPLACEMENT - UPPER  .
    Fig 2: Installing Fuel Pipe Clip And Bolt
    G02081451Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals