Installation Procedure
WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
- Install the engine mount bracket. Refer to ENGINE MOUNT BRACKET REPLACEMENT
.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
- Install the engine mount bracket with the engine mount to the oil pan.
- Install the engine mount bracket-to-oil pan bolts.
Tighten
Tighten the engine mount bracket bolts to 58 N.m (43 lb ft).
- Lower the engine.
- Install the engine mount lower nuts.
Tighten
Tighten the engine mount lower nuts to 43 N.m (32 lb ft).
- Install the right engine splash shield. Refer to SPLASH SHIELD REPLACEMENT - ENGINE in Body Front End.
- Install the right front wheel and tire. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in Tires and Wheels.
- Connect the three-way catalytic converter pipe to the right (rear) exhaust manifold. Refer to CATALYTIC CONVERTER REPLACEMENT (3.1L) in Engine Exhaust.
- Lower the vehicle.
- Remove the engine support fixture.
- Install the engine mount struts. Refer to ENGINE MOUNT STRUT REPLACEMENT .
- Install the throttle body air inlet duct.
- Connect the battery ground (negative) cable. Refer to BATTERY NEGATIVE CABLE DISCONNECT/CONNECT PROCEDURE in Battery.