LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 121 (Engine Controls Removal & Installation) >> Ignition Systems >> Crankshaft Position Sensor >> Removal

Crankshaft Position Sensor: Removal

WARNING: This page is about a different car, the 2002 GMC Safari and 2002 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition off. Raise and support vehicle. Remove steering linkage shield mounting bolts and steering linkage shield (if equipped).
  2. Disconnect Crankshaft Position (CKP) sensor harness connector. CKP sensor harness connector is located on front of engine, behind crankshaft pulley. See Fig 1 . Remove CKP sensor mounting bolt and CKP sensor.
Fig 1: Locating Crankshaft Position Sensor
G00028213Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals