LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1206 (Vibration Symptoms Diagnosis And Correction) >> Diagnostic Information and Procedures >> Tire and Wheel Assembly Runout Measurement - On-Vehicle

Tire and Wheel Assembly Runout Measurement - On-Vehicle

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE .
  2. Closely inspect each tire for proper and even bead seating.
  3. If any of the tire beads were not properly or evenly seated, reseat the tire bead, then proceed to step 4. Refer to TIRE MOUNTING AND DISMOUNTING .
    Fig 1: Measuring Tire & Wheel Assembly Radial Runout
    G02708793Courtesy of GENERAL MOTORS CORP.
  4. Wrap the circumference of each tire with tape (1) in the center tread area. Wrapping the tread with tape allows for a smooth and accurate reading of radial runout to be obtained.
  5. Position the dial indicator on the taped portion of the tire tread such that the dial indicator is perpendicular to the tire tread surface.
  6. Slowly rotate the tire and wheel assembly one complete revolution in order to find the low spot.
  7. Set the dial indicator to zero at the low spot.
  8. Slowly rotate the tire and wheel assembly one more complete revolution and measure the total amount of radial runout.

    Specification 

    Maximum tire and wheel assembly radial runout - measured on-vehicle: 1.52 mm (0.060 in)

    Fig 2: Positioning Dial Indicator On Tire Sidewall
    G02708794Courtesy of GENERAL MOTORS CORP.
  9. Position the dial indicator on a smooth portion of the tire sidewall, as close to the tread as possible, such that the dial indicator is perpendicular to the tire sidewall surface.
  10. Slowly rotate the tire and wheel assembly one complete revolution in order to find the low spot. Ignore any jumps or dips due to sidewall splices.
  11. Set the dial indicator to zero at the low spot.
  12. Slowly rotate the tire and wheel assembly one more complete revolution and measure the total amount of lateral runout. Ignore any jumps or dips due to sidewall splices and attain an average runout measurement.

    Specification 

    Maximum tire and wheel assembly lateral runout - measured on-vehicle: 1.52 mm (0.060 in)

  13. Repeat steps  4 -  12 until all of the tire and wheel assembly radial and lateral runout measurements have been taken.
  14. Lower the vehicle.
scientia non olet · About LEMON Manuals