Ignition and Key Alarm Switch Assembly - Assemble - Off Vehicle

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.

Install the ignition and key alarm switch assembly (1) onto the electronic lock module assembly.
NOTE: Refer to FASTENER NOTICE .
Screw the 2 tapping screws (2) into the ignition and key alarm switch assembly (1).

Fig 1: Installing Ignition & Key Alarm Switch Assembly
Courtesy of GENERAL MOTORS CORP.

Tighten

Tighten the screws to 1.5 N.m (13 lb in).
Install the key alarm connector (1) into the electronic lock module assembly (2).
1. 3.1. Push the key alarm connector (1) into the electronic lock module assembly (2).
2. 3.2. Rotate the key alarm connector (1) 90 degrees so that the key alarm connector (1) locks into place.
  
  Fig 2: Installing Key Alarm Connector
  Courtesy of GENERAL MOTORS CORP.
Screw the TORX ® head screw (1) into the electric park lock (3).
Tighten

Tighten the screw to 1.5 N.m (13 lb in).
Reconnect the connector (2) into the electric park lock (3).

Fig 3: Installing Electric Park Lock
Courtesy of GENERAL MOTORS CORP.
Slide the PASSKEY ® III (2) onto the electronic lock module assembly (1).

Fig 4: Installing PASSKEY® III
Courtesy of GENERAL MOTORS CORP.
Slide the 2 connectors (2) of the turn signal and multifunction switch assembly into the bulkhead connector (1).

Fig 5: Sliding Turn Signal & Multifunction Switch Assembly Connectors Into Bulkhead Connector
Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to SIR INFLATOR MODULE COIL CAUTION .
Attach new wire harness straps to the wire harness assembly (1) and the steering column.
Install the wire harness assembly (1) into the wire harness strap (2).
Install the upper and lower trim covers. Refer to Steering Column Trim Covers - Assemble - Off Vehicle .
Enable the inflatable restraint steering wheel module. Refer to ACTIVATING SYSTEM .

Fig 6: Installing Wire Harness Assembly
Courtesy of GENERAL MOTORS CORP.