Under the Rear Suspension Crossmember
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
Important:
- The service jack lift pad must not come in contact with the rear suspension mono-leaf spring.
- Carefully observe the following:
- Be sure to place a block or pad between the jack lift pad and the vehicle.
- Make sure the jack lift pad spans at least 2 suspension crossmember ribs (1).
- Lift only in the areas shown.
Position the service jack lift pad as follows:
Spanning the 2 suspension crossmember ribs (1).