LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1182 (Bumper System) >> Repair Instructions >> License Bracket Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the license bracket with the center locating tab in the slot in the fascia.
  2. Install the back-up lamp sockets.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the license bracket screws.

    Tighten 

    Tighten the license bracket screws to 2 N.m (18 lb in).

  4. Install the license plate.
  5. Install the license plate screws

    Tighten 

    Tighten the license bracket screws to 2 N.m (18 lb in).

  6. Install the license plate frame.
Fig 1: License Bracket
G01450930Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals