Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the nuts attaching the reflector to the fascia.
Tighten

Tighten the reflector nuts to 2.3 N.m (20 lb in).

Fig 1: Rear Bumper Fascia Reflector
Courtesy of GENERAL MOTORS CORP.
Install the taillamp to the fascia opening.
Install the taillamp screws.

Fig 2: Taillamp
Courtesy of GENERAL MOTORS CORP.

Tighten

Tighten the taillamp screws to 2 N.m (18 lb in).