Removal & Installation (2.2L)

WARNING: This page is about a different car, the 2002 Pontiac Grand Am, 2002 Oldsmobile Alero, and 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition off. Disconnect Ignition Control Module (ICM) harness connector. See Fig 1 . Remove ICM retaining screws. Remove ICM from ignition coil housing. Remove ignition coil housing retaining bolts. Remove ignition coil housing from camshaft cover.
To install, reverse removal procedure. Tighten bolts to specification. See TORQUE SPECIFICATIONS .

Fig 1: Removing & Installing Ignition Coil Housing & Ignition Control Module (2.2L)

Courtesy of GENERAL MOTORS CORP.