Removal (Quick-Connect Fitting - With Plastic Collar)
WARNING: This page is about a different car, the 2002 Pontiac Grand Am, 2002 Oldsmobile Alero, and 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Release fuel system pressure. See FUEL SYSTEM PRESSURE RELEASE .
- Squeeze the plastic tabs of the male end connector. See Figure . Pull the connection apart. Using a clean shop towel, wipe off the male pipe end. Inspect both ends of the fitting for dirt and burrs.
- If necessary, remove rust or burrs from the fuel pipes with an emery cloth. Use a radial motion with the fuel pipe end in order to prevent damage to the "O" ring sealing surface. Clean or replace the components and assemblies as required.
WARNING:
Wear safety glasses when using compressed air, as flying dirt particles may cause eye injury. Blow dirt out of the fitting using compressed air.