Removal & Installation (3.1L & 3.4L)
WARNING: This page is about a different car, the 2002 Pontiac Grand Am, 2002 Oldsmobile Alero, and 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
Turn ignition off. Remove the bolts that attach the Manifold Absolute Pressure (MAP) sensor to the bracket. See Fig 1 . Disconnect the electrical connector from the MAP sensor. Disconnect the MAP sensor inlet vacuum hose. Remove MAP sensor from the bracket. To install, reverse removal procedure. Tighten MAP sensor retaining bolts to specification. See TORQUE SPECIFICATIONS .