LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1176 (Instrument Panel, Gages, And Console) >> Repair Instructions >> Bracket Replacement - Knee Bolster (Driver Outer) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the console. Refer to CONSOLE REPLACEMENT .
  2. Remove the IP accessory trim plate. Refer to TRIM PLATE REPLACEMENT - INSTRUMENT PANEL (I/P) ACCESSORY .
  3. Remove the driver knee bolster trim panel. Refer to TRIM PANEL REPLACEMENT - KNEE BOLSTER .
    IMPORTANT: The following step must be performed to assure proper trim fits during installation.
    Fig 1: Removing Driver Side Outer Knee Bolster Bracket
    G01453908Courtesy of GENERAL MOTORS CORP.
  4. Mark the location of the driver knee bolster outer bracket. Refer to INSTRUMENT PANEL (I/P) DISASSEMBLY PRECAUTIONS .
  5. Remove the screws retaining the driver knee bolster outer bracket to the steering column bracket.
  6. Remove the driver knee bolster outer bracket.
scientia non olet · About LEMON Manuals