Removal Procedure
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the roof bow interior trim panel. Refer to TRIM PANEL REPLACEMENT - REAR ROOF BOW in Interior Trim.
- Remove the left rear compartment side trim panel. Refer to TRIM PANEL REPLACEMENT - REAR COMPARTMENT FRONT SIDE (COUPE) or TRIM PANEL REPLACEMENT - REAR COMPARTMENT FRONT SIDE (CONVERTIBLE) or TRIM PANEL REPLACEMENT - REAR COMPARTMENT FRONT SIDE (HARDTOP) in Interior Trim.
- Remove the left lock pillar trim panel. Refer to TRIM REPLACEMENT - LOCK PILLAR (UPPER CONVERTIBLE) or TRIM REPLACEMENT - LOCK PILLAR (COUPE) or TRIM REPLACEMENT - LOCK PILLAR (LOWER CONVERTIBLE AND HARD TOP) in Interior Trim.
- Disconnect the rear lift window antenna coaxial extension cable from the antenna buffer.
- Beginning at the antenna buffer end, carefully remove the push-in fastener retainers securing the coaxial extension cable along the roof bow.
- Remove the push-in fastener retainers securing the coaxial extension cable to the lock pillar and the front seat back reinforcement panel.
- Disconnect the coaxial extension cable from the antenna module.
- Remove the coaxial extension cable.