DTC Parameters
WARNING: This page is about a different car, the 2002 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Throttle plate rest position has been commanded.
- Currently in throttle learn mode.
- Engine speed is less than 250 RPM.
- Vehicle speed zero MPH.
- ECT is between 41-212°F (5-100°C).
- IAT is greater than 5°C (41°F).
- Accelerator pedal angle is less than 15 percent.
- Battery voltage is greater than 10 volts.
DTC sets if the throttle plate is 3 percent above the throttle rest position for longer than 0.56 second.
DTC P2119 diagnostic runs during a throttle relearn procedure or key up closed throttle test when the above conditions have been met.
NOTE:
The MIL will illuminate after 5 seconds.